Bedienung
27
Commissioning
• Pick up the chainsaw.
• Use the left hand to hold the front handle (2) rmly.
• Use the right hand to hold the rear handle (11) rmly. The heel of the hand rests on the throttle
interlock (9) and the index nger operates the throttle lever (10) (see g. D).
• After pressing the throttle lever (10) once, the engine runs at idle speed.
• Allow the engine to warm up briey.
9.4 Checking and adjusting chain lubrication
m ATTENTION
• Never work without chain lubrication! If the saw chain runs dry, the cutting gear will be
irreparably destroyed in a short time.
• Always check chain lubrication before working.
Note
Only use saw chain oil, preferably biodegradable. Do not use waste oil, engine oil, etc.
Check during work that the chain lubrication is working.
Hold the chainsaw during operation, at medium speed, over a sawed-o tree stump or a suitable
surface. If the lubrication is sucient, a light lm of oil will form on the tree stump or surface (see
g. E).
• If necessary, the chain lubrication can be increased or decreased by means of the oil ad-
justment screw (19).
• Use the screwdriver (30) supplied to help:
- First press and then turn the oil adjustment screw (19) clockwise to reduce chain lubri-
cation.
- First press and then turn the oil adjustment screw (19) anti-clockwise to increase chain
lubrication.
9.5 Checking the chain brake
m WARNING
The chain brake must be checked before each use.
The chain brake brakes the saw chain immediately in the event of kick-back.
• Make sure that the front hand guard (1) is free of dirt and moves easily.
• Start the chainsaw and accelerate the saw chain to full speed (full throttle).
• With the saw chain running, operate the front hand guard (1). The chain brake must brake
and lock the saw chain at max. speed.
To Next Page
Loading...
