Useful work tips
The following information helps you to achieve the best possible
results when working with the device:
- It allows you to screw threaded screws into soft woods
without pre-drilling. For other woods, we recommend pre-
drilling the hole, especially in the case of large screw
diameters.
- Countersink the drill holes if you want to use countersunk
screws.
- When using screws without a continuous thread, pre-drill
approximately half the screw length.
Screwing
1. Insert a bit (see section Inserting bits).
2. Set the torque selector
(see section Setting the torque).
Start with a slow speed and increase this as required.
3. Set the desired rotational direction with the left/right rotation
switch
.
4. Insert the bit straight into the slot and/or the slots of the
screws.
5. Press the ON/OFF switch
to turn the device
on.
6. To stop screwing, let go of the ON/OFF switch.
7. Let the device and the accessories cool down completely once
you have finished your work.
8. Remove the bit.
Operation
30
To Next Page
Loading...
