Correction value K: 1.5 m/s
2
Scope of delivery bit set: 54 bits, 25 mm CRV
3 x PH0, 3 x PH1, 3 x PH2, 3 x PH3, 2 x PZ0, 2 x PZ1,
2 x PZ2, 2 x PZ3,
2 x SL3, 2 x SL4, 2 x SL5, 2 x SL6, 2 x SL7,
2 x H3, 2 x H4, 2 x H5, 2 x H6,
2 x T8, 2 x T10, 2 x T15, 2 x T20, 2 x T25, 2 x T27, 2 x
T30, 2 x T40
1 x magnetic bit holder
Noise/vibration information
The specified total vibration value and the specified noise
emission values have been measured according to a standardized
test method (EN62841-1/EN62841-2-2) and can be used to compare
one power tool with another. They can also be used for a
preliminary assessment of exposure.
Measured according to DIN EN 62841-2-2. The noise level of 85 dB
(A) is not exceeded. Protective measures are nevertheless
recommended for the user (wear suitable hearing protection).
Also take into account possible deviations in the national
regulations for the permitted workplace values.
Warning!
The vibration and noise emissions can deviate from the stated
values during actual use of the power tool. This depends on the
way the power tool is actually used and especially on the type of
workpiece you are working on.
It is necessary to establish safety measures that protect the
operator based on an estimate of the exposure during actual
conditions of use (taking into account all parts of the operating
cycle, such as periods when the power tool is switched off and
periods when it is switched on but running without load).
Technical data
34
To Next Page
Loading...
