To Next PageTo Next PageWhat to do if I have a Ferroli BlueHelix HiTech RRT C fan fault?
If you're experiencing a fan fault with your Ferroli boiler, begin by checking the 5-pin connector wiring to ensure there's a 230V power supply. Check the fan and replace it if necessary.
How to fix specific combustion control errors in Ferroli BlueHelix HiTech RRT C?
To address specific combustion control errors in your Ferroli boiler, first, check that the fume ducts and the condensate trap are not blocked. Also, check the correct gas supply pressure. If necessary, do the CO adjustment in TEST mode and perform the Calibration procedure [AUTO SETUP] if the condensate trap is blocked.
How to troubleshoot overtemperature protection intervention in Ferroli BlueHelix HiTech RRT C?
If your Ferroli boiler's overtemperature protection is intervening, check the flow sensor for correct positioning and operation, replacing it if necessary. Make sure there is water circulation in the system by inspecting the circulating pump and heating system. Additionally, vent the system to eliminate any air.
What causes exchanger protection intervention in Ferroli BlueHelix HiTech RRT C?
Exchanger protection intervention in your Ferroli boiler can occur due to a few reasons. Check the circulating pump and heating system to ensure proper water circulation. Vent the system if there's poor circulation and an anomalous flow probe temperature increase. Inspect the exchanger and system for blockages.
Why does my Ferroli BlueHelix HiTech RRT C overtemperature protection activate?
Overtemperature protection in your Ferroli boiler may activate due to several reasons. Check the flow or return sensors for correct positioning and operation, replacing them if necessary. Ensure there is adequate water circulation in the system by checking the circulating pump. Also, vent the system to remove any air.
How to fix Ferroli BlueHelix HiTech RRT C no burner ignition?
If your Ferroli boiler's burner isn't igniting, several factors could be at play. First, ensure gas is flowing to the boiler and that air has been purged from the pipes. Next, inspect the ignition/detection electrode for proper wiring, positioning, and cleanliness; replace if needed. Also, verify sufficient gas supply pressure. Check the trap and clean it if necessary. Clear any obstructions from air/fume ducts. Calibrate the system using the AUTO SETUP procedure. Lastly, check the gas valve and replace it if faulty.
What to do if there is no flame after the ignition phase in my Ferroli Boiler?
General| Type | Condensing |
|---|---|
| Fuel Type | Natural Gas / LPG |
| Weight | 32 kg |
| Efficiency Class | A |
| Mounting | Wall-mounted |
| Modulation | 1:10 |
| Heat Exchanger Material | Stainless Steel |
| Control | Digital |
| Warranty | 2 years |
| Output | 24 kW |
| Efficiency | Up to 98% (EN 92/42) |
