36
EN
cod. 3541S180 - Rev. 04 - 09/2019
Battery: The icon on the screen is activated when the battery level is too low.
» Thermostat connected to an on-off boiler, the icon indicates request status.
» Thermostat connected to an OpenTherm boiler, the icon indicates burner status.
Note At rst activation the thermostat is congured automatically in On-Off wire
connection mode.
When the thermostat and the WiFi receiver are connected to the wireless network,
the thermostat automatically switches to RF On-Off.mode.
When the WiFi receiver is connected to an OpenTherm boiler, the thermostat auto-
matically switches to RF OpenTherm mode.
If the thermostat has been congured as RF (on-off or OpenTherm) it does not
automatically switch to on-off wire mode. This can only be done by removing and
putting back the batteries.
: in manual or automatic mode, the icon indicates that the appliance is active.
Note: The icon is only present in the case of RF connection with OpenTherm boilers.
: the icon indicates that heating is active.
Note: The icon is only present in the case of RF connection with OpenTherm boilers.
: the room temperature or errors are displayed:
E82: RF communication error
E83: OpenTherm communication error
To Next Page
Loading...
Need help?
General
