How do I fix a faulty outlet sensor on my Ferroli Boiler?
If the outlet sensor is faulty in your Ferroli Boiler, it's likely due to a damaged sensor or cut wiring. Check the wiring, and if necessary, replace the sensor.
What to do if there is insufficient water system pressure in my Ferroli ECONCEPT 50 A?
If you have insufficient water system pressure in your Ferroli Boiler, it's likely the system is empty. Fill the system to 1.5 bar to resolve this issue.
How to fix failed burner assembly ignition on Ferroli ECONCEPT 50 A?
If the Ferroli Boiler burner assembly fails to ignite, it could be due to several reasons. First, ensure that gas is flowing correctly to the boiler and that any air has been purged from the piping. Second, inspect the ignition or detection electrode for wiring issues, correct positioning, and any deposits. Finally, a defective gas valve could be the culprit, requiring a check and potential replacement.
Why is the central heating outlet temperature too high on my Ferroli Boiler?
If the central heating outlet temperature of your Ferroli Boiler is excessively high, it could be due to a blocked or faulty pump. Try freeing the pump by removing the cap and rotating the shaft with a screwdriver. If that doesn't work, the pump may be faulty, so check or replace the condenser or the pump itself.
What causes a return sensor fault in a Ferroli Boiler?
If the return sensor is faulty in your Ferroli Boiler, it's likely because the sensor is damaged or the wiring is cut. Check the wiring and replace the sensor if needed.
How to fix a faulty microprocessor in my Ferroli Boiler?
If the microprocessor is faulty in your Ferroli Boiler, disconnect and restore the electrical power supply. If the problem persists, check and/or replace the main board.
How to fix a failed burner assembly ignition in my Ferroli ECONCEPT 50 A?
If the burner assembly fails to ignite in your Ferroli Boiler, several factors could be at play. First, ensure the boiler is receiving gas and that the piping is free of air. Next, inspect the ignition or detection electrode for proper wiring, correct positioning, and any deposits. If these steps don't resolve the issue, the gas valve may be defective and require checking or replacement. There may also be a faulty full auto control.
What to do if the safety thermostat activates in my Ferroli ECONCEPT 50 A Boiler?
If the safety thermostat is activated in your Ferroli Boiler, it could be due to a couple of reasons. Check the positioning and operation of the outlet sensor. Also, verify the system circulation by inspecting the pump.
How to fix a faulty return sensor on Ferroli ECONCEPT 50 A Boiler?
If the return sensor on your Ferroli Boiler is faulty, it could be due to a damaged sensor or cut wiring. Check the wiring, and if damaged, replace the sensor.
Why is the central heating return temperature too high in my Ferroli ECONCEPT 50 A?
If the central heating return temperature is excessively high in your Ferroli Boiler, it is likely due to no system circulation. Check both the system and the pump to ensure they are functioning correctly.
General| Fuel Type | Natural Gas / LPG |
|---|---|
| Nominal output | 50 kW |
| Efficiency Class | A |
| NOx Class | 5 |
| Max working pressure | 3 bar |
| Mounting | Wall-mounted |
| DHW Output (kW) | 50 |
To Next Page