EXTERNO
Cod. 3541T440 - Rev. 05 - 02/2020
40
EN
5. REMOTE CONTROL
LED Display
(Display water
temperature
and error codes)
ECO Indicator
Temperature
Adjustment
Buttons
ECO Button
Water Flow
Signal
Fan Signal
Flame Signal
Power On/O
Button
6. IGNITION PROCEDURE
• ensure that the valve located on the cold water fitting is open.
• ensure that the gas valve is open.
• ensure the the device is powered by electric current.
1. Press ON/OFF button, the display lights up.
The appliance is ready to operate.
The set temperature is indicated on the display.
1
By opening a hot water valve, the appliance automatically starts operating.
2. The display shows the set temperature and the flame indica-
tes success of burner ignition.
2
WARNING!!
Water with a temperature higher than 50°C cause serious burns. Always verify water temperature before
use.
Note: If the appliance does not operate, ensure that the gas and/or cold water valves are open. Ensure
that the device is electrically powered. When closing the valve, the appliance automatically switches off
and the flame symbol disappears from the display.
To Next Page