You will need to clean your Sensor twice each day:
1st time: before you insert it for overnight use.
2nd time: after you have used it overnight so that it is clean
when you place it on the Reader.
When you are not using the Sensor, clean it and store it in its
cradle on the Reader with the lid closed – this will keep it clean
and secure.
2.3 Inserting Your Sensor
The Sensor is shaped like a tampon and made of a special
medical grade material.
This material is naturally slippery, but if you find that the
Sensor is ‘dry’ to insert, apply a very small amount of standard
water-based lubricant gel approved for vaginal use, such as
K-Y Jelly®, Durex Play® Feel®, or Sensilube®. DO NOT use gels
with "flavour", "warming" or "cooling" additives.
1. Clean the Sensor as outlined in Section 2.2. Then wash
your hands.
2. Hold the Sensor where the tail joins the main body.
3. Get into a comfortable position.
4. The Sensor is inserted just as you would a tampon (4a and
4b)
5. The Sensor tail is designed to hang outside of your body.
If you feel any discomfort, the Sensor may not be placed
far enough inside. If this happens, gently remove and try
again.
To Next Page
Loading...