Festo 32 MPA - Page 3

2009/06 – Subject to change
3
 Internet: www.festo.com/catalogue/...
Valve terminals type 32 MPA
Key features
Reduced downtimes:
Two-colour LED diagnostics on site
Reliable operation:
Manual override non-detenting/detenting or with cover
Width 10 mm and 20 mm
Safe:
Operating voltage connection ±25%, outputs
and valves can be disconnected separately
Compact:
Slim valves and flat plate silencers
Flexible:
– 64 valve positions/128 solenoid coils (FB)
– 24 valve positions/24 solenoid coils (MP)
Functional:
Sturdy metal thread or pre-assembled QS
fittings
Wide range of valve functions
Practical:
Large inscription labels
Quick mounting:
Directly using screws or on a H- rail ,
automatic earthing
CPX diagnostic interface for hand -
held devices (channel-oriented diag-
nostics down to the individual valve)
Pneumatic interface to CPX
Straightforward electrical onnections
– Multi-pin plug connection
– Fieldbus connection
– Control block
–AS-interface
–CPI
Modular:
Supply plates facilitate the creation of
multiplepressurezonesaswellasnumer-
ous additional exhaust and supply ports
Equipment options
Valve functions
• 5/2-way valve, single solenoid
• 5/2-way valve, double solenoid
• 2x 3/2-way valve,
normally open
• 2x 3/2-way valve,
normally closed
• 2x 3/2-way valve,
1x normally open,
1x normally closed
• 5/3-way valve,
mid-position pressurised
• 5/3-way valve,
mid-position close d
• 5/3-way valve,
mid-position exhausted
• 2x 2/2-way valve,
1x normally closed,
1x normally closed, reversible
• 2x 2/2-way valve,
normally closed
• 1x 3/2-way valve,
normally closed,
external compressed air supply
• 1x 3/2-way valve,
normally open,
external compressed air supply
• Manual pressure regulators
• Proportional pressure regulators
• Pressure sensor
All valves have the same compact
dimensions with an overall length of
107 mm and a width of 10.5 mm or
21 mm. A height of 55 mm makes
them a perfect matc h for the electrical
peripherals CPX.
Special features
Multi-pin terminal
• Max. 24 valve positions/
max. 24 solenoid coils
• Parallel modular valve linking via
circuit boards
• Electronics module with integrated
holding current reduction
• Any compressed air supply
• Creation of pressure zones
Fieldbus terminal/control block
• Max. 64 valve positions/
max. 128 solenoid coils
• Internal CPX bus system for valve
actuation
• Module for electrical valve actua-
tion, via separate voltage supply or
without electrical isolation
• Any compressed air supply
• Creation of pressure zones
Individual valve
• Electrical M8 connection, 4-pin
with screw connection
• Detachable electronics module with
integrated holding current
reduction
AS-interface
• 2 to 8 valves, freely configurable
(max. 8 solenoid coils) with input
feedback
CPI interface
• Max. 32 valve positions/
max. 32 solenoid coils
Combinable
• MPA1 flow rates up to 360 l/min
• MPA2 flow rates up to 700 l/min
• MPA1 and MPA2 c an be combined
on one valve terminal
Electrical supply plate
• Increases the maximum number of
valve positions possible to 64, with
max. 128 solenoid coils
• Creation of isolated, individually
disconnectable electrical circuits
(voltage zones)
• Greater economy thanks to the
higher number of valves/solenoid
coils per valve terminal
• Greater safety through individual
disconnection of valve groups, for
example for EMERGENCY-S TOP
functions
-H- Note
The electrical supply plate is
available with either an M18 or
7/8” connection.