Contents and general instructions
Festo CDPX-… en 1203NH
ii
Designated use
The display and operator panels described in this manual
have been designed exclusively for use with PLC systems. The
devices may only be used as follows:
– in accordance with designated use
– in their original state
– without any modifications by the user
– in faultless technical condition.
If additional commercially-available components such as
sensors and actuators are connected, the specified limits for
pressures, temperatures, electrical data, torques, etc. must
not be exceeded.
Please observe the standards specified in the relevant
chapters and comply with technical regulations, as well as
with national and local regulations.
To Next Page
Loading...
