Festo CTEU-PB - Page 6

Contents and general safety instructions
IV
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English
2.2 Preparing the bus node for configuration 2-7............................
2.2.1 Addressing the bus node 2-7.................................
2.2.2 Modules/devices at I-Port connection 1 and 2 2-7................
2.3 Installation on a higher-level controller 2-10.............................
2.3.1 Device master file (GSD) and symbol files 2-10....................
2.4 Configuration by using process data 2-12...............................
2.4.1 Configuration examples 2-12..................................
2.4.2 Configuration of a DP master 2-16..............................
2.4.3 Bus start-up 2-16............................................
2.4.4 Configuration using a DP master from Siemens as an example 2-17...
2.5 Identification and maintenance 2-26....................................
2.5.1 Overview of the I&M data structures 2-26........................
2.5.2 Load identification properties into the bus node using Step 7 2-27....
2.5.3 Check identification properties using S tep 7 2-28..................
2.6 Parameterisation (DP) 2-31...........................................
2.6.1 Parameterisationw hen being swit ched on (start behaviour) 2-32.....
2.6.2 Equipment parameters 2-32...................................
2.6.3 Parameterisation of the bus node 2-33..........................
2.6.4 Bus node parameters tool change 2-34..........................
2.6.5 Application example for the parameterisation 2-37................
2.7 Communication 2-38................................................
2.7.1 Statuses whe n communication is established 2-38.................
2.7.2 Status transitions 2-38.......................................
2.8 Fail state behaviour 2-40.............................................
2.9 Switching on 2-42...................................................
2.9.1 Information concerning the swit ch-on behaviour of the bus node 2-42.
2.9.2 Checklist before switching on 2-43..............................
2.9.3 Switching on the power supply 2-44............................
2.9.4 Normal operating status 2-44..................................