Contents and general safety instructions
VII
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English
Intended use
The bus node CTEU-PB documented in this description has
been designed exclusively for use as a station (slave) on the
PROFI BUS-DP fieldbus.
The bus node may only be used as follows:
–asintended
– in original condition, without unauthorised modifications.
Only the conversions or modifications des cr ibe d in the
docume n t at i o n suppl i e d wi t h th e product are permi t te d.
– in excellent technical conditio n.
The limit values specified for pressures, temperatures,
electrical data, torques etc. must be complied with.
Observe the regulations of the trade associations, German
Technical Control Board (TÜV), VDE stipulations or corres-
ponding national laws and regulations.
Range of application and certifications
The product fulfils the requirements of E U directives and is
marked with the CE marking.
S tandards and test values which the product complies with
and fulfils can be found in the Technical appendix. The
product-relevant EC directives can be found in the declaration
of conformity.
Certificates and declarations of conformity for this product
can be found at www.festo .com.
To Next Page
Loading...
