12
DF700 EQ
The illustrations specified are located at the
beginning of the operating manual.
1 Symbols
Symbol Significance
Warning of general danger
Risk of electric shock
Read operating instructions and
safety notices!
Wear ear protection.
Wear protective gloves.
Wear a dust mask.
Disconnect from the power supply!
Burning risks from hot surfaces!
Do not dispose of as domestic
waste.
2 Technical data
Joiner DF 700 EQ
Power 720 W
Speed (no load) n
0
21000 rpm
Routing depth 15 – 70 mm
Routing width, max. 16.5 mm + Ø cutter
Joiner DF 700 EQ
Ø cutter, max 14 mm
Connecting thread of the
drive shaft
M8 x 1
Weight (excl. cable) 5.2 kg
Safety class
/ II
3 Machine features
[1-1] Rubber buffer
[1-2] Stop pins
[1-3] Handles
[1-4] ON/OFF switch
[1-5] Display for dowel hole width
[1-6] Adjusting lever for dowel hole width
[1-7] Slide for routing depth adjustment
[1-8] Snap button for routing depth adjustment
[1-9] Marker for routing depth adjustment
[1-10] Unlocking of motor unit / guide frame
[1-11] Selection slide for routing height adjust-
ment
[1-12] Clamp lever for routing angle adjustment
[1-13] Button for releasing stop pins
[1-14] Clamp lever for routing height adjustment
[1-15] Extractor connector
[1-16] Spindle lock
[1-17] Mains power cable
4 Intended use
The machine is intended to create DOMINO dowel
connections in hard and soft wood, chipboard,
plywood and fibreboard. All applications beyond
this are regarded as unintended use.
The machine is designed and approved for use by
trained persons or specialists only.
The user is liable for improper or non-
intended use.
5 Safety instructions
5.1 General safety instructions for power
tools
WARNING Read all safety instruc-
tions, other instructions and technical data
provided with this power tool, and take a look at
the illustrations. Failure to observe the following
instructions may lead to electric shocks, fires and/
or serious injuries.
Keep all safety and other instructions in a safe
place for future reference.
The term “power tool” used in the safety instruc-
tions refers to mains-powered power tools (with
Symbols............................................................ 14
Technical data .................................................. 14
Machine features .............................................14
Intended use .................................................... 14
Safety instructions ........................................... 14
Operation ......................................................... 17
Settings ............................................................ 17
Working with the machine ............................... 19
Service and maintenance ................................ 20
Accessories ...................................................... 20
Environment ..................................................... 20
Troubleshooting ............................................... 21
Original operating instructions
Table of contents
To Next Page
Loading...
