Festool Domino XL DF 700 EQ - Troubleshooting

19
DF700 EQ
12 Troubleshooting
Fault Cause Solution
Burns Blunt cutter Use sharp cutter.
Dowel hole too narrow,
DOMINO dowel cannot be
jointed
a. Blunt cutter
b. Deposits (e.g. chippings in
the dowel hole)
a. Use sharp cutter.
b. Remove deposit and work
with dust extractor.
Widening of the dowel hole
with 8mm cutter
Routing depth too large (larger
than 50 mm)
Reduce routing depth (max.
50mm).
Splinters at edge of dowel hole Excessive feed rate Reduce feed rate.
Dowel hole not parallel to
workpiece edge
Workpiece has shifted during
processing
Secure workpiece properly.
Tool cannot be loosened during
tool change
Spindle lock not functioning Twist spindle against the tool
using an open-ended spanner.
If this occurs several times
contact the after-sales service
department.
The positions of the dowel
holes which are created with
one of the left and one of the
right stop pins do not match
precisely.
The stop pins are selected
different on the right and left
Select the same stop pins on
the left and right.
DOMINO joining machine
operates irregularly, jerks
a. No dust extractor connected
b. Rubber buffer [1-1] worn
a. Connect dust extractor.
b. Replace rubber buffer (spare
part).