15
DF700 EQ
– Do not resharpen cutters more than twice.
Resharpened cutters may affect the precision
of the cutting results.
– Do not operate the tool if the spring-loaded
fence does not return to its forward rest
position. The fence covers the mortising bit and
prevents accidental contact. If the slides of the
fence do not move freely, have the tool serviced
immediately.
5.3 Emission levels
Levels determined in accordance with EN 60745
are typically:
Sound pressure level L
PA
= 83 dB(A)
Noise level L
WA
= 94 dB(A)
Measuring uncertainty allowance K = 3 dB
CAUTION
Operating noise
Damage to hearing
XUse ear protection.
Vibration emission value a
h
(vector sum for
three directions) and uncertainty K measured in
accordance with EN 60745:
Vibration emission level (3 directions)
Handle a
h
< 2.5 m/s
2
Uncertainty
K = 1,5 m/s
2
The specified emission values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with
other insertion tools or if not maintained
adequately. Take note of idling and downtimes of
machine!
6 Operation
WARNING
Unauthorised voltage or frequency
Risk of accident
XThe mains voltage and the frequency of the
power source must correspond with the
specifications on the machine’s name plate.
Always switch the machine off before
connecting or disconnecting the mains
power cable!
Connecting and detaching the mains power cable
[1-17] see Fig. [2].
The switch [1-4] is an on/off switch (I = ON,
0=OFF).
XPeel off the protective film from the bottom of
the guide frame [3-4].
XRemove the transport safety device [1-18].
7 Settings
WARNING
Risk of injury, electric shock
XAlways pull the mains plug out of the socket
before performing any type of maintenance
on the machine!
7.1 Electronics
The machine features full-wave phase control
electronics with the following features:
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through
electronic control to ensure a uniform cutting
speed even when under load.
Temperature cut-out
The machine power supply is limited and the
speed reduced if the motor exceeds a certain
temperature. The machine continues operating
at reduced power to allow the ventilator to cool
the motor quickly. If the machine temperature
exceeds the maximum permitted value for longer
periods, the machine switches off completely after
approx. 40 seconds and can only be switched on
again once the motor has cooled sufficiently.
Restart protection
The integral restart protection prevents the
machine from automatically starting up again
after an interruption in power when the machine
is used in continuous operating mode. In this
case the machine must be switched off and then
switched back on again.
To Next Page
Loading...
