16
DF700 EQ
7.2 Changing tools
CAUTION
Hot and sharp tools
Risk of injury
XDo not use insert tools that are blunt or
defective.
XWear protective gloves.
Removing the tool
XLift the unlocking device [3-2] until it audibly
disengages using the open-ended spanner
[3-3] supplied (SW 12).
XSeparate the motor unit [3-5] from the guide
frame [3-4].
XPress and hold the spindle lock [4-1].
XLoosen the cutter [4-3] using the open-ended
spanner [4-2] and remove.
XRelease the spindle lock [4-1].
Inserting the tool
WARNING
Risk of injury
XBefore inserting a new cutter ensure that the
machine, the guide frame and the guides [3-1]
and [3-6] are clean.
XRemove any contamination that may be
present.
XOnly use sharp, undamaged and clean tools..
XPress and hold the spindle lock [4-1].
XUse the open-ended spanner [4-2] to screw on
the cutter [4-3].
XRelease the spindle lock [4-1].
XSlide the guide frame [3-4] onto the motor unit
[3-5] until it audibly engages.
7.3 Setting the Mortise Depth
WARNING
Cutter can come out at the rear side of the
workpiece.
Risk of injury
XSet the routing depth at least 5 mm less than
the workpiece thickness.
XPress one or two snap buttons [1-8].
XSet the slide for the routing depth setting [1-7]
to the desired routing depth (15 - 70 mm).
XRelease the snap buttons [1-8].
XCheck whether the slide [1-7] has engaged
correctly.
With the two markers [1-9], you can mark
two routing depths and switch easily
between them using the slide [1-7] (e.g.
for asymmetric DOMINO dowel depth
distribution).
7.4 Setting the Fence Height
The alignment of the clamp levers [1-12]
and [1-14] can be aligned by raising the
levers. When tightened, the levers should
not protrude beyond the contact surface.
a) with selection slide
XLoosen the clamp lever for the routing height
adjustment [5-1].
XUsing the front handle [5-2] raise the front part
of the guide frame.
XUse the selection switch to set [5-6] the desired
routing height h (10 mm; 15 mm; 20 mm;25 mm;
30 mm; 40 mm).
XPress the front section of the guide frame
downwards as far as the stop.
XClose the clamp lever [5-1].
b) freely selectable
XLoosen the clamp lever for the routing height
adjustment [5-1].
XUsing the front handle [5-2] raise the front
section of the guide frame.
XPull the selection slide [5-6] as far as the stop
in the direction of the motor unit.
XSet the desired routing height h using the scale
[5-3] by moving the front section of the guide
frame vertically.
XClose the clamp lever [5-1].
7.5 Setting the Fence Angle
XLoosen the clamp lever for the angle adjustment
[5-4].
XSet the desired angle:
Xusing the scale [5-5] variable from 0° to 90°.
Xlocking at 0°; 22.5°; 45°; 67.5°; 90°.
To Next Page
Loading...
