Festool KSC 60 EB - Page 15

4B
4B-1
– Fastening clamps
[4C] : Use fastening
clamps [4C-1] to secure the machine to the
work surface. The support points are used
to firmly secure the machine while taking
the centre of gravity into consideration.
4C
4C-1
– Clamping set (for MFT)
[4D]: Use the
clamping set [4D-2] to secure the machine
onto the Festool MFT 3 or MFT/Kapex (SZ-
KS) multifunction table. The hexagonal
holes [4D-1]
close to the extension table on
both sides are used for this.
4D
facultative:
opcional:
optional:
SZ-KS
4D-1
4D-2
– Underframe
UG-KAPEX KS 60 [4E]: Ob
serve the installation instructions that are
enclosed with the underframe.
UG-KAPEX KS60/UG-AD-KS60
facultative:
opcional:
optional:
4E
English
15