The pictures for the functional description are
on a fold-out page at the beginning of the in
struction manual. While reading the manual
you can fold out the page for comparison and
quick reference.
Accessories shown or described are not always
included in the scope of delivery.
7 Commissioning
7.1 Initial commissioning
CAUTION
Risk of tilting!
► Ensure that the power tool is securely
positioned.
► If required, observe the installation in
structions for the MFT multifunction table
or underframe UG-KAPEX KS 60.
► Remove the transport safety device [3]
.
▷ Remove the protective sleeve from the
left-hand pulling rail
.
▷ Push the saw unit down, thus breaking
through the cable ties that are securing
it in place .
▷ Remove the clamp from around the tilt
locking device
.
► Set up the machine and move it into the
working position.
7.2 Setting up and securing [4]
WARNING
Risk of injury
► Remove both battery packs from the power
tool before performing any work on the
power tool.
Secure the machine in such a way that it cannot
slip when you are working on it.
Support feet [4A]
Before securing, if required, install the
A‑SYS‑KS60
support feet. Thanks to these sup
port feet, the work surface on the rotary base is
at the same height as a Systainer 1 and
Systainer
3
SYS3 M 112. These Systainers mean
that long workpieces can then be supported.
You have the following options for securing:
– Screws
[4B]: Use four screws to secure
the machine to the work surface. Use the
holes [4B-1]
at the four support points on
the saw table to do this.
English
14
To Next Page
Loading...
