Festool KSC 60 EB - Angle Adjustment and Cutting; Setting Mitre Angles; Adjusting Individual Mitre Angles; Sawing Inclined (Bevel) Cuts

11A
4
0
1
0
5
0° 15° 22,5° 30° 45° 60°
0° 15° 22,5° 30° 45° 60°
Setting individual mitre angles
► Release the rotary knob .
► Press the detent lever and let it click in
to place by pressing on it at the left.
► Continuously swivel the rotary base into the
required position .
► Close the rotary knob .
4
0
1
0
5
0 - 60°
0 - 60°
11B
10.8 Sawing inclined cuts [12]
Moving or removing the stop rulers
may make it necessary to implement special
settings for inclined cutting, see section 9.6
.
Inclination to the left between 0° and 45°
► Loosen the star handle
.
► Tilt the saw unit to the required cutting an
gle .
► Tighten the star handle .
Inclination to the right between 0° and 45°:
► Loosen the star handle .
► Press the release button ; if required,
relieve the tension by slightly tilting it in the
opposite direction.
► Tilt the saw unit to the required cutting an
gle .
► Tighten the star handle
.
46–47° inclination to the right/left
(undercutting)
► Loosen the star handle .
► Press the release button ; if required,
relieve the tension by slightly tilting it in the
opposite direction.
► Tilt the saw unit to the limit stop .
► Press the release button again .
► Tilt the saw unit again .
English
23