12
Customer service and repair
only
through manufacturer or service work-
shops: Please find the nearest address at:
www.festoolusa.com/service
Use only original Festool spare parts!
Order No. at:
www.festoolusa.com/service
Note the following information:
– Keep the ventilation slits on the machine free and
clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
For service, maintenance, disposal and
transport of the battery pack, note enclosed
instructions of the battery pack!
Accessories
Use only original Festool accessories and Festool
consumable material intended for this machine.
These components are designed specifically for
this machine. Using accessories and consumable
material from other suppliers will most likely affect
the quality of your results and limit warranty
claims. Machine wear or your own personal work-
load may increase depending on the application.
Protect yourself and your machine, and preserve
your warranty claims by always using original Fes-
tool accessories and Festool consumable material!
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festoolusa.com".
Systainer
Many Festool products are shipped in a unique sys-
tem container, called "Systainer". This provides
protection and storage for the tool and accessories.
The Systainers are stackable and can be inter-
locked together. They also can be interlocked atop
Festool CT dust extractors.
To open the Systainer
To lock the Systainer
To connect two Systainers
Place one Systainer on the top of the other (Fig.
[9 A]
).
The Systainers are connected and locked.
L
A new generation Systainer is connectable on
top of a previous generation Systainer by the
four latches of the previous Systainer.
Environment
Do not dispose of the device as domestic waste!
Dispose of machines, accessories and packaging at
an environmentally responsible recycling centre.
Observe the respective national regulations.
EKAT
1
2
3
5
4
Turn the T-loc
[9-1]
to this position.
Turn the T-loc
[9-1]
to this position.
Turn the T-loc
[9-1]
to one of this posi-
tions (Fig.
[9 B]
).
open
lock
connect
connect
T-loc
9-1
A
9
B
To Next Page
Loading...
Need help?
General
