4
Safety instructions
General safety instructions
WARNING! Read all safety warnings and all
instructions.
Failure to follow the warnings
and instructions may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future ref-
erence.
The term “power tool” in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
1 WORK AREA SAFETY
a.
Keep work area clean and well lit.
Cluttered and
dark areas invite accidents.
b.
Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust.
Power tools create sparks
which may ignite the dust or fumes.
c.
Keep children and bystanders away while oper-
ating a power tool.
Distractions can cause you to
lose control.
2 ELECTRICAL SAFETY
a.
Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools.
Unmodified plugs and matching outlets
will reduce risk of electric shock.
b.
Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators.
There is an increased risk of elec-
tric shock if your body is earthed or grounded.
c.
Do not expose power tools to rain or wet condi-
tions.
Water entering a power tool will increase
the risk of electric shock.
d.
Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts.
Damaged or entangled cords in-
crease the risk of electric shock.
e.
When operating a power tool outdoors, use an
extension cord suitable for outdoor use.
Use of
a cord suitable for outdoor use reduces the risk of
electric shock.
f.
If operating a power tool in a damp location is
unavoidable, use a residual current device
(RCD) protected supply.
Use of an RCD reduces
the risk of electric shock.
3 PERSONAL SAFETY
a.
Stay alert, watch what you are doing and use
common sense when operating a power tool. Do
not use a power tool while you are tired or under
the influence of drugs, alcohol or medication.
A
Wear protective gloves.
Wear a dust mask.
Wear protective goggles.
Tip or advice
Handling instruction
diameter
Max. chuck clamping
Vvolts
A amperes
Hz hertz
~ a.c. alternating current
Symbol Significance
d.c. direct current
n
0
no load speed
rpm
min
-1
revolutions per minute
°C degree Celsius
°F degree Fahrenheit
min. minutes
Ah amps hour
kg kilograms
lb. pound
Wh watt hour
Nm Newton metre
mm millimetre
’’ inch
To Next Page
Loading...
Need help?
General
