Festool PDC 18/4 Instruction Manual

9
An acoustic signal sounds when the preset torque
is reached and the machine then switches off. You
must release and press the ON/OFF switch [1-4]
again to start the machine.
Drilling
Mark is aligned with drill symbol = maximum
torque.
Impact drilling
L The machine was designed for impact drilling
into tiles, masonry and stone.
Set the selector switch [1-6] to the hammer symbol.
Set the adjusting wheel
[1-8] to the drill symbol.
Tool holder, attachments
L Prior to initial use: apply multi-purpose grease
to the drill spindle and gearbox neck.
CENTROTEC tool chuck [3]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Wear gloves when replacing!
Chuck [4]
For clamping drill bits and bits with max. shaft di-
ameter of 13 mm.
Clamp tool centrally in the chuck.
WARNING
Risk of injury
X Always disconnect the battery pack before per-
forming any type of work on the machine!
CAUTION
Hot and sharp tools
Risk of injury
X Do not use insert tools that are blunt or defective.
X Wear protective gloves.
3
click
3
4
click
1
2
4
2
3
click
1
4
5

Festool PDC 18/4 Specifications

General

Brand	Festool
Model	PDC 18/4
Category	Drill
Language	English