14
Dust extraction
A Festool mobile dust extractor with an extractor
hose diameter of 27 mm or 36 mm (36 mm recom-
mended due to the reduced risk of clogging) can be
connected to the extractor connector
[1-4]
.
Festool CTL/M 36 E AC
PLANEX
mobile dust
extractors are adapted to the quantity of dust
generated and permanently ensure the neces-
sary suction power.
Recommendation:
Use anti-static extractor hose!
This helps reduce the electric charge.
Working with the power tool
To switch on the power tool, see Section Com-
missioning.
Carefully place the sanding head onto the sand-
ing surface.
Perform the sanding work.
Do not apply too much pressure on the power
tool as this will cause overloading. The best
sanding results are achieved with moderate ap-
plication pressure. The sanding performance
and quality depend mainly on selecting the cor-
rect abrasive.
After finishing work
Once you have finished the sanding work, set
the power tool down.
CAUTION! Do not set the power tool down
with the sanding head facing downwards –
always lay it on the floor so that it is on its
side with the brush ring facing down.
Other-
wise the sanding pad could be deformed.
To protect the sanding pad and the sanding
head, always transport and store the power tool
in the accompanying carry bag without the
sanding discs.
WARNING
Heath hazard posed by dust
Always work with an extractor.
Comply with national regulations.
Wear a dust mask.
WARNING
Risk of injury
Do not hold the power tool by the sanding head.
Hold the power tool with both hands using the
gripping surfaces
[1-10]
.
To Next Page
Loading...
