18
If problems other than those listed occur, please contact your Festool service workshop or your local spe-
cialist dealer.
Information on data protection
The power tool contains a chip which automatically
stores machine and operating data (RFID). This
data saved cannot be traced back directly to an in-
dividual.
The data can be read using special (contactless) de-
vices and shall only be used by Festool for fault di-
agnosis, repair and warranty processing and for
quality improvement or enhancement of the power
tool. The data shall not be used in any other way
without the express consent of the customer.
Sanding marks on the
surface
Sanding pad is placed down on
the surface at an angle
Place the sanding pad down so that it is
level.
The abrasive grit is too coarse for
very soft spackling paste.
Choose a finer abrasive grit (abrasive
Brilliant 2 available up to grit P 320).
LHS-E 225 switches off
while working and after
three beeps
Cool air filter on the LHS-E 225 is
blocked.
Clean the cool air filter on the LHS-E 225,
see Section. Cleaning the cool air filter [8]
.
Excessive pressure -> power tool
activates overheating protection.
Let the power tool cool down for approx.
15 minutes and then apply less pressure.
LHS-E 225 not working plug it is not connected correctly. Check that the plug it is securely con-
nected.
Interruption to power supply Switch the power tool off and on again.
LHS-E 225 not working
and beeps three times
when an attempt is made
to switch it on
Overheating protection active Let the power tool cool down for approx.
15 minutes before switching it back on
again.
Problem Possible causes Remedy
To Next Page
Loading...
