[1-10]
Rotational direction switch and safety
lock/transport lock
[1-11]
Handle
[1-12]
Thumbwheel for torque/drilling/light
ing duration on and duration off
[1-13]
Belt clip
[1-14]
Bit store
[1-15]
Insulated gripping surfaces (grey
shaded area)
Accessories shown or described are not always
included in the scope of delivery.
The pictures for the functional description are
on a fold-out page at the beginning of the in
struction manual. While reading the manual
you can fold out the page for comparison and
quick reference.
7 Battery pack
Before using the battery pack, check that the
battery interface is clean. Any contamination of
the battery interface may impair correct contact
and lead to the contacts being damaged.
A faulty contact may result in the machine over
heating or being damaged.
[3A]
Remove the battery pack.
[3B]
Insert the battery pack – until it
clicks into place.
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
8 Commissioning
CAUTION
Risk of injury
► Only assemble when the power tool is
switched off!
8.1 Belt clip [1-13]
The belt clip allows the power tool to be attach
ed to work attire for brief periods. It can be at
tached to the right or left of the power tool us
ing a screw [4].
8.2 Fitting the auxiliary handle [5]
WARNING! Always use the auxiliary handle.
► Check that the auxiliary handle [5-1] is se
curely in place.
English
11
To Next Page
Loading...
