EasyManuals Logo

Festool TPC 18/4 User Manual

Festool TPC 18/4
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Position 1 = low torque
Position 13 = high torque
There is a signal when the set torque is
reached and the power tool switches off. The
power tool only starts up again if the on/off
switch [1-5] is released and pressed again.
Drilling
Marking shows the drill symbol
= maxi
mum torque.
9.4 Adjust lighting [1-12]
Configure lighting at the thumbwheel [1-12].
Marking shows position 1 to 13 or drill sym
bol .
The LED light [1-4] automatically
switches on and off with the power tool. The
LED light has an afterglow for a short time after
the tool has been switched off.
Marking shows lighting duration on/
maximum torque.
Briefly apply pressure
on the on/off switch [1-5] to permanently
switch the LED light on. After ten minutes, the
LED light automatically switches off.
Marking shows lighting duration off/
maximum torque.
The LED light is perma
nently switched off.
9.5 Impact drilling
Move the selector switch [1-8] to the hammer
symbol . Set the thumbwheel [1-12]
to the
drill symbol
.
9.6 Festool Work app
The power tool can be configured with the
Festool Work app.
The battery pack is connected via
Bluetooth
®
, see the operating manual for
the battery pack.
10 Tool holder, attachments
WARNING
Risk of injury
Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp insertion
tool
Do not use any blunt or faulty insertion
tools.
Wear protective gloves when handling an
insertion tool.
Prior to initial use: Apply some multipur
pose grease to the drill spindle.
10.1 CENTROTEC tool chuck [7]
Fast changeover of tools with CENTROTEC
shaft.
WARNING! Only clamp CENTROTEC tools in
CENTROTEC tool chucks.
Wear gloves when replacing tools.
WH-CE
CENTROTEC®
klick
1
2
3
4
7
10.2 Chuck
[8]
For clamping drill bits and bits with max. shaft
diameter of 1/2" (13 mm).
WARNING! Clamp the tool centrally in the
chuck.
English
13

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Festool TPC 18/4 and is the answer not in the manual?

Festool TPC 18/4 Specifications

General IconGeneral
Battery Voltage18V
Gears4
Chuck Capacity1.5 - 13 mm
Weight (with battery)1.8 kg
Drilling Diameter in Wood/Steel50/13 mm
Battery TypeLi-Ion
Chuck Size13 mm
No-Load Speed0 - 3600 rpm

Related product manuals