11 Working with the electric
power tool
WARNING
Risk of injury
► Only position the power tool on the screw
when it is switched off.
► Always secure the workpiece in such a
manner that it cannot move during ma
chining.
► Keep hands away from the rotating tools.
CAUTION
Risk of burns
The tool holder and tool may become very
hot during operation.
► Allow them to cool down before attaching
them to the belt clip.
11.1 Kickback stop
WARNING
Risk of injury
The kickback stop does not guarantee com
plete protection against a kickback.
► Always concentrate on your work and refer
to the safety instructions and warnings.
The kickback stop is triggered if the tool
is jammed, causing the power tool to
rotate around the screw axis suddenly
and unexpectedly. The power tool switches off,
beeps once and the LED light flashes continu
ously.
After the kickback stop has been triggered:
► Release the on/off switch [1-5]
.
► Eliminate the cause of the jam.
► Press the on/off switch again.
11.2 Bit store
[1-14]
CAUTION
Risk of injury from metal cuttings in the bit
store.
► Clean the bit store regularly and clear out
metal cuttings.
Magnetic, for storing bits and bit holders.
12 Warning signals
Warning signals occur and the power tool switches off in the following operating states:
English
15
To Next Page
Loading...
Need help?
General
