You are done with set up and
your templates are all ready to
use at a moment’s notice. Just
mount the template making
sure the cam on the bottom of
the black in/out adjustment
wheels is against the VS-600
when you tighten the two
rotary knobs to secure the
template in place. Position
your work pieces under the
clamps as outlined in this
manual, set the router bit
depth using the test pieces you
saved and you are “good to
go.”
From this point
forward, you will
cut perfect half-
blind dovetailed
drawers in under
five minutes and
through-dovetailed
drawers in under
fifteen minutes.
Cut the work pieces
to the proper size,
mount them as
indicated and make
perfect joints every
time.
35
To Next Page
Loading...
