Fetco MBS-1221 - A PROGRAM

Go to fetco.com for the latest versions of all information Page 6 User Guide & Operator instructions MBS-1221 P202Re0August 2021
A PROGRAM
Menu Features: Batch Parameters
The settings below are shown for the first batch and third bottons on the brewer. Second batch is user optional.
See how to access all A menus on the previous page. Below are the brew settings for default A1 & A3 batches
POSITION Program Items Factory set Default Programming Range Increments Notes
A11
[Coffee]
Batch Volume
2.20liters
0.58gal
0.95 to 4.0L
0.25 to 1.06 gal
0.05L
0.01G
Unit software is in liters;
Can convert to gallon
A12
Brew Time
(MIN:SEC)
3:30 minutes 2:00 – 12:00 15 sec
Default total brew time is
5:00 minutes
A13 Prewet Perc. 0% 0.00 – 25.0% 1%
Percentage of total brew
volume
A14
Prewet Delay
(Pause after prewet
completes)
0% [1:00 Min] [0:10 – 5:00] 10 sec
The time between
prewetting and start of
brew cycle.
This feature appears
ONLY if Prewet >0:00
A16 Drip Delay 1:30 mm:ss 0:30 – 6:00 min. 10 sec
Time brew basket should
remain in place during final
drip-out
Drip delay remains “ON”
for 2:00 minutes if STOP is
pressed during brew †
A20
[User Set]
Batch Enabled
A20 NO +
NO OFF/Coffee/or Tea Select Batch presets below
A20 Batch Type
Appears only
when enabled
OFF/Coffee/Tea See below
Selectable by user to be
an additional batch setting
“COFFEE"
Will set brewer to COFFEE presets as in A10-A20 (above) Middle button will activate and illuminate.
“TEA”
Will set brewer to TEA presets as in A30-A39 (below) Middle button will activate and illuminate.
“OFF”
Middle button will be inactive and will be unlit.
A30
[Iced Tea]
Batch Enabled
A30 YES -
NO +
YES
(Active)
Middle and Bottom
batches A2,A3
Batch on
or off
Batches may be
individually enabled,
rewritten or deactivated
A31 Batch Volume
2.30liters
0.58gal
0.95 to 4.0L
0.25 to 1.06 gal
0.05L
0.01G
Unit software is in liters;
converts to gallon
A32 Brew Time 3:00 minutes 2:00 – 12:00 15 sec
Default total brew time is
5:00 minutes
A33 Prewet Percent 0% 0.00 – 25.0% 1%
Percentage of total brew
volume
A34
Prewet Delay
(see A14 above)
0% [1:00 Min] [0:10 – 5:00] 10 sec
Time between prewetting
and start of brew cycle.
A36
Drip Delay
1:30 mm:ss
0:30 – 6:00 min.
10 sec

See Note A16
A37 Dilution Mode Normal Normal/Fast
NORMAL: Dilution after
the brew is completed
FAST: Dilution is during
the brew cycle
A37 Dilution Delay 0.10 0:00 –12:00 min 10 sec
Pause after brew to begin
dilution. Often used to
add sweetener
A37 Dilution Volume
9.1 liters
2.4 gallons
0:00 –15:15 liters
0:00 –4:0 gallons
0.05L
0.01G
Unit software is in liters;
converts to gallon
A39 Batch Temp
204°F
95.6°C
200°F-207°F
93°-96°C
1°F
1°C
Activates only wen brewer
is in Tea Brewer mode
A90
Copy Batch
A91
Copy From
Copy From Batch 1 + A91 1 (1-6) Select recipe to copy
A92
(PASTE TO)
Paste To Batch? 1 + A92.1 (1-6) Select where to paste
A10 (Left Batch COFFEE) and A30 (Right Batch TEA) cannot be disabled.
A20 middle batch may be set for coffee or tea or disabled.
† DRIP DELAY will not activate when STOP is pressed within 5 seconds of starting a brew time
.