Fetco MBS-1221 - Starting The Brew; Enter Programming; Enter Programming to Make Changes; Exit Programming & Save Settings

Go to fetco.com for the latest versions of all information Page 4 User Guide & Operator instructions MBS-1221 P202Re0August 2021
STOP
EXIT
H NO +
Starting The Brew
1. Turn the power switch “ON”.
2. Prepare a brew basket with the correct size filter and appropriate amount of coffee or tea.
3. Slide the brew basket completely into the rails.
4. Place a clean, empty, preheated dispenser under the brew basket.
5. Select a batch & hold the corresponding BREW button in for 1 second to start
6. -STOP button will illuminate, Brew Selector button will illuminate
-Countdown time will display. Default time setting is 5:00 (coffee) 6:45 (iced tea
-Selected BREW button will slowly pulsate to indicate brew is in progress.
-All other BREW buttons for that brew head will be unlit.
7. When the brew cycle is finished,
STOP button will extinguish and the BREW button will continue to pulsate to indicate DRIP
will display to show the 1.30 (one and one-half minutes) drip delay setting.
This indicates that coffee may still be dripping from the brew basket
For safety- do not remove brew basket until drip-out is complete.
Enter Programming
There are 7 menu groups-A-F plus EXIT (G).
See the following pages for the batch parameter definitions and all settings for the brewer
TO ENTER PROGRAMMING
1-Turn brewer “OFF” from power switch
2-Turn power switch to “ON”
…Screen will initialize and then
display digital process notifications
3-After Initialization- “STOP” Lamp turns on
4-Quickly press “STOP” button (no need to hold)
When brewer is In PROGRAMMING MODE
-the screen will display:
|BATCH PRG|
|A (or B-F) |
-Illuminated LED indicates active keypad positions
See the following pages for batch parameter definitions
and all settings for the brewer
Enter Programming to Make Changes
Section B –“General Settings” to change tank temperature shown below
Enter Programming-Press
STOP button until the
General Settings (“B”)
screen appears
From the “B” screen
Press button 1 to toggle
to the Tank Temperature
Screen (default is 200°)
From Tank Temp screen
Toggle buttons 2 or 3 to
select the desired
temperature
From Tank Temp screen
Press button 1 to toggle
to the next selection in
General Settings or SAVE
To SAVE and EXIT
Press the STOP
button to
the “H” screen. Proceed
to screen two below
Exit Programming & Save
Control Setting Changes
From any screen-
Press
STOP button until the
EXIT (“H”) screen
appears
From the “H” screen
Press button 2 to
toggle to the EXIT-YES
screen
From EXIT screen
Press button 1 to
toggle to the SAVE
screen
From SAVE screen
Press button 2 to
toggle to the SAVE-
YES screen
To SAVE and EXIT
Press button 1 to
SAVE your changes
and EXIT to
OPERATING MODE
STOP
General Settings
B
STOP
Brew at Temp
B2 YES-
STOP
EXIT
H NO +
STOP
Programming A-H
A-H
STOP
EXIT
H YES -
STOP
SAVE
H NO +
STOP
SAVE
H YES -
STOP
Brewing
4:40[C]5:45[IT]
STOP
FETCO
Ready to Brew
MBS-1221
Ver.2.0a.201221
STOP
Batch Program
A
STOP
STOP BUTTON
↓
ON/OFF switch
is located on
lower right on
back of brewer
STOP
Tank Temperature
B1 200°F+-
STOP
Tank Temperature
B1 171° to 207°