Fiat DOBLO 2016 - Adjusting the Buzzer Volume (Buzz); Multifunction Display

Adjusting the buzzer
volume (bUZZ)
This function is used to adjust the
volume of the audible signal (buzzer)
that sounds in the event of failure/
warning indications and when
the MENU ESC,
and buttons are
pressed.
To set the desired volume, proceed as
follows:
- press the MENU
button briefly:
the display will show the wording
(bUZZ);
- press
or to select the required
volume (adjustable over 8 levels).
- press the MENU
button briefly to
return to the menu screen or hold the
button down to return to the standard
screen without storing.
Activation/Deactivation
of passenger side front
and chest/head side
protection (side bags)
airbags (BAG P)
(for versions/markets, where
provided)
This function allows the passenger side
airbag to be activated/deactivated.
Proceed as follows:
- press the MENU
button and, after
the message BAG P OFF (to
deactivate) or BAG P On (to activate) is
displayed by pressing buttons
or
, press MENU again;
- a confirmation message will appear
on the display;
- press the
or buttons to select
(YES) (confirming activation/
deactivation) or (no) (to abort);
- press the MENU
button briefly: a
message confirming the selection will
be displayed and you will return to
the menu screen or, pressing the button
for longer, you will return to the
standard screen without saving.
Daytime running lights
(DRL)
This function allows you to activate/
deactivate the daytime running lights.
Proceed as follows to activate or
deactivate this function:
- press the MENU
button briefly:
the display will show the wording DRL;
- press the
or button to activate
(On) or deactivate (Off) the daytime
running lights;
- press the MENU
button briefly to
return to the submenu screen or hold
the button down to return to the main
menu screen without saving;
MULTIFUNCTION
DISPLAY
(for versions/markets, where provided)
The vehicle may be equipped with a
multifunction display that gives the
driver useful information depending on
the previous settings.
STANDARD SCREEN
The standard screen fig. 116 can
display the following information:
A Date
B Milometer (distance covered in km or
miles).
C Time (always displayed, even with the
key extracted and the front doors
closed).
D Outside temperature.
E Headlamp alignment position (only
with dipped headlamps on).
F Start&Stop function indication (for
versions/markets, where provided).
G Gear Shift Indication (for versions/
markets, where provided).
Note When one of the front doors is
opened, the display is activated,
showing the time and mileage for a few
seconds.
73