Fiat Doblo - Page 153

Reducing the stored
speed
This can be done in two ways:
❒ by deactivating the device and then
storing the new speed
or
❒ by moving the stalk downwards (-)
until the new speed, which will
automatically remain memorised, is
reached.
Each movement of the stalk will
correspond to a slight reduction in
speed of about 1 km/h, while
keeping the stalk held downwards
will decrease the speed
continuously.
Deactivating the
device
The device can be switched off by
the driver in the following ways:
❒ by turning ring nut A to the
OFF position;
❒ if the engine is stopped (leaving the
stalk ring nut at ON), when the
ignition key is next turned to ON,
Cruise Control will be activated
automatically.
Deactivating the
function
The device can be switched off by
the driver in the following ways:
❒ by pressing the brake pedal when the
device is adjusting the speed:
❒ by pressing the clutch pedal when
the device is adjusting the speed;
❒ by pressing button B fig. 146 when
the device is adjusting the speed
(for versions/markets, where
provided);
❒ by pressing the accelerator pedal (in
this case the system is not actually
turned off but the acceleration
request takes priority; the cruise
control remains activated, without the
need to the press button B fig. 146
to restore the previous conditions
once the acceleration is over).
The device is automatically switched
off in the following cases:
❒ if the ABS or ESC systems intervene
❒ with the vehicle speed below the
set limit
❒ in the event of system failure.
WARNING
95) When travelling with the device
active, never move the gear lever
to neutral.
96) In the event of device faults or
failures, turn the ring nut A to
OFF and contact a Fiat
Dealership.
149