Fiat Doblo - BODYWORK

WINDSCREEN/REAR
WINDOW WIPER
(for versions/markets, where
provided)
BLADES
Periodically clean the rubber part
using special products; TUTELA
PROFESSIONAL SC 35 is
recommended.
Replace the blades if the rubber
edge is deformed or worn. In any
case, it is advisable to replace them
approximately once a year.
A few simple precautions can
reduce the possibility of damage to
the blades:
❒ if the temperature falls below zero,
make sure that ice has not frozen
the rubber against the glass. Use a
de-icing product to release it if
required;
❒ remove any snow from the glass: in
addition to protecting the blades,
this prevents effort on the motor and
overheating;
❒ do not operate the windscreen and
rear window wipers on dry glass.
138)
Replacing the
windscreen wiper
blades fig. 215
Proceed as follows:
❒ lift up the windscreen wiper arm;
❒ push retaining device A and, at the
same time, slide the blade from the
arm by pushing it in the direction
shown in the diagram.
Replacing the rear
window wiper blade
fig. 216-fig. 217
(for versions/markets, where
provided)
Wing door versions fig. 216
Proceed as follows:
❒ press the retaining tag A and pull the
brush out making it slide in the
direction indicated by the arrow.
Swing door versions fig. 217
Proceed as follows:
❒ press the retainer reversely operating
as shown, then remove the blade.
215
F0V0090
216
F0V0250
217
F0V0211
212
SERVICING AND MAINTENANCE