REAR ROOF LIGHT
To replace the bulb, proceed as
follows:
❒ remove roof light A fig. 170 working
at the points indicated by the arrows;
❒ open the cover B fig. 171 as
indicated;
❒ replace the bulb C fig. 172 releasing
the side contacts, insert the new
bulb and make sure that it is correctly
locked between the contacts;
❒ close the cover B fig. 171 and secure
the roof light into its housing, making
sure it locks properly into place.
Removable roof light
To replace the bulb, proceed as
follows:
❒ press button A fig. 173 and extract
the removable roof light B;
❒ remove the roof light, working at the
points indicated by the arrows;
❒ replace bulb C fig. 174 releasing the
side contacts, insert the new bulb
and make sure that it is correctly
locked between the contacts;
REPLACING FUSES
INTRODUCTION
Fuses protect the electric system:
they blow in the event of a failure or
improper action on the system.
When a device does not work,
check the condition of its protective
fuse: the filament A fig. 175 must
be intact.
170
F0V0075
171
F0V0071
172
F0V0072
173
F0V0176
174
F0V0177
168
IN AN EMERGENCY