EXTENDING THE BOOT
Proceed as follows:
❒ open the rear doors and remove the
parcel shelf (as described previously);
❒ completely lower the rear seat head
restraints;
❒ move the seat belt to the side,
making sure that it is fully extended
and not twisted;
❒ lift backrest retainer lever A fig. 82
and fold the backrest forwards to
give you a flat loading area. When
you lift the lever, you will see a red
band.
❒ to widen the load compartment
further, lift lever B fig. 83 on the side
of the cushion that will raise
automatically; intervene manually to
fold seat and backrest completely
forward fig. 84.
On versions with backrest folded
down and parcel shelf folded down
(for versions/markets, where
provided) a load compartment can
be created fig. 85.
In the low position, the parcel shelf
can support a maximum load of
70 kg on a minimum bearing surface
of 400 mm × 400 mm fig. 86.
N.B. There are bands on the rear
seats under the cushion to attach
the folded seat to the front seat
head restraint rods.
80
F0V0136
81
F0V0137
82
F0V0127
83
F0V0202
84
F0V0203
62
KNOW YOUR VEHICLE
To Next Page
Loading...
