12
STANDBY MODE
In Standby Mode the device is in deep sleep state allowing for safe
dismounting, transporting and low as possible battery consumption.
The device is shipped in Standby Mode.
Entering the device in Standby Mode will not factory reset the device
nor will result in loosing any data, but calibration and sensor pairing
(after long Standby) is lost.
#10: Standby Mode
To exit Standby Mode click the button once, the device will enter
rst installation procedure.
To enter Standby Mode:
1. Use the included key to press and hold the button.
2. Release the button when you see cyan LED colour.
3. Quickly click the button to conrm.
4. Wait for the LED to stop blinking.
To Next Page
Loading...
