FIBARO FGBHT-001 - 2: Basic Activation

4
BASIC ACTIVATION
1. Connect the charger to the micro-USB port to charge the device.
2. Disconnect the charger when the LED ring pulses green (device
fully charged).
3. Dismount your current thermostatic head.
4. Depending on type of your thermostatic valve:
5. Mount the device on the valve and tighten it by turning the cap
clockwise.
#2: Basic activation
M30 x 1.5
Danfoss RTD-N
Danfoss RA-N
Proceed normally
Use adapter:
Use adapter:
NOTE
In order to achieve
the best performance
install the device in
horizontal position.
CAUTION
Do not cover or veil the
thermostatic head.
!
NOTE
First charging may take
up to 3 hours.
i
CAUTION
If you use one of the
adapters, double check
that it is mounted
properly. It should
click when putting on
the valve, hold tight
after installing and
not rotate!
!
i