Plug insertion detection:
The Wall Plug detects if any device is plugged into it and reports it to
your iOS device.
Overload Control*:
Functionality allows to switch o connected load after 4 seconds
from exceeding the power set by the user in Fibaro for HomeKit app.
Power Change Notication*:
Minimum and maximum allowed power consumption may be de-
ned by the user in Fibaro for HomeKit app. Exceeding any of these
values results in sending a notication.
Timer Switch*:
Functionality allows to set time (in Fibaro for HomeKit app) after
which connected load will be automatically turned on/turned o.
Timer will start after changing the ON/OFF state to opposite (through
the app or connected wall switch). If the device state was changed
before expiring of the set time, the counter will reset.
It is possible to use both Turn ON and Turn OFF functionality - it will
result in cyclic load control.
To Next Page
Loading...
