FIBARO FGFS-101 User Manual

4
DESCRIPTION AND FEATURES
Main features of FIBARO Flood Sensor:
• compatible with any Z-Wave or Z-Wave+ Controller,
• supports protected mode (Z-Wave network security mode) with AES-
128 encryption,
• may be connected to any alarm system (potential free output
terminal),
• extremely easy installation - simply put on a surface prone to ooding,
• may be installed anywhere - ood sensor’s contacts extended
with a wire,
• battery or VDC powered. When connected to an external 12/24V DC
power source, the battery serves as an emergency power source,
• theft protection - tilt or moving is reported to the Z-Wave network or
alarm system’s main controller,
• two operating modes - ood/temperature sensor or just a
temperature sensor,
• alarm is signalled by sound, visual indicator (LED diode) and Z-Wave.
FIBARO Flood Sensor is a universal, Z-Wave Plus compatible, ood
and temperature sensor. The device can be powered using battery,
12/24V DC power supply or both. Flood alarm is sent to the Z-Wave
network devices or additionally to any alarm system controller
through opening a NC contact using the external power supply.
The device has built in temperature sensor that allows to monitor
ambient temperature. FIBARO Flood Sensor is designed to be placed
on the oor or mounted on a wall (in this case Flood Sensor probes
should be extended using addition wire). The device has a built-in
visual LED indicator and an acoustic alarm.
In addition, the sensor is equipped with a tilt sensor reporting tilt or
movement to the main controller e.g. when someone has taken the
Sensor from its original location.
FIBARO Flood Sensor is sink-proof, which means it drifts on the water
surface and keeps on sending alarm signal in case of substantial
inundation of water.
#1: Description and features
FIBARO Flood Sensor is a fully
compatible Z-Wave PLUS device.
NOTE
This device may be
used with all de-
vices certied with
the Z-Wave Plus cer-
ticate and should be
compatible with such
devices produced by
other manufacturers.
i
NOTE
FIBARO Flood Sensor
is a Security Enabled
Z-Wave Plus product
and a Security Ena-
bled Z-Wave Control-
ler must be used in or-
der to fully utilize the
product.
i

FIBARO FGFS-101 Specifications

General

Type	Freestanding
Purpose	Indoor/outdoor
Accuracy	0.5 °C
Connectivity technology	Wireless
Humidity measuring range	0 - 40 %
Battery type	CR123A
Number of batteries supported	1
Storage temperature (T-T)	- °C
Built-in display	No

Weight and Dimensions

Width	72 mm
Height	28 mm