FIBARO FGFS-101 User Manual

6
ADDING/REMOVING THE DEVICE
#3: Adding/removing the device
NOTE
Adding in security
mode must be per-
formed up to 2 meters
from the controller.
i
NOTE
Removing FloodSensor
from the Z-Wave net-
work restores all the
default parameters of
the device.
i
NOTE
In case the Sensor is
not added, please re-
set the Sensor and re-
peat the adding pro-
cedure.
i
Adding (Inclusion) - Z-Wave device learning mode, allowing to add
the device to existing Z-Wave network.
To add the device to the Z-Wave network:
1. Open the cover.
2. Place the Sensor within the direct range of your Z-Wave controller.
3. Set the main controller in (security/non-security) add mode (see
the controller’s manual).
4. Quickly, three times press the TMP button.
5. Wait for the adding process to end.
6. Successful adding will be conrmed by the Z-Wave controller’s
message.
Removing (Exclusion) - Z-Wave device learning mode, allowing to
remove the device from existing Z-Wave network.
To remove the device from the Z-Wave network:
1. Open the cover.
2. Place the Sensor within the direct range of your Z-Wave controller.
3. Set the main controller into remove mode (see the controller’s
manual).
4. Quickly, three times press the TMP button.
5. Wait for the removing process to end.
6. Successful removing will be conrmed by the Z-Wave controller’s
message.
TMP
button
TMP
button

FIBARO FGFS-101 Specifications

General

Type	Freestanding
Purpose	Indoor/outdoor
Accuracy	0.5 °C
Connectivity technology	Wireless
Humidity measuring range	0 - 40 %
Battery type	CR123A
Number of batteries supported	1
Storage temperature (T-T)	- °C
Built-in display	No

Weight and Dimensions

Width	72 mm
Height	28 mm