FIBARO ROLLER SHUTTER 3 Manual

o the device added to the Z-Wave network,
o parameter 151 is set to 1 or 2.
2. Press and hold UP or DOWN switch for at least 3 seconds
3. Press and hold the same switch again for at least 3 seconds.
4. Press and hold the same switch again for at least 3 seconds.
5. The device will perform the calibration process, completing full cycle – up, down and up
again.
6. Test whether the positioning works correctly.
Calibration using the B-button
1. Make sure:
o the device is supplied,
o the device added to the Z-Wave network,
o parameter 151 is set to 1 or 2.
2. Press and hold the B-button.
3. Wait for the LED to glow white.
4. Quickly release and click the B-button again.
5. The device will perform the calibration process, completing full cycle – up, down and up
again
6. Test whether the positioning works correctly.
Calibration using parameter
1. Make sure:
o the device is supplied,
o the device added to the Z-Wave network,
o parameter 151 is set to 1 or 2.
2. Set the parameter 150 value to 2
3. The device will perform the calibration process, completing full cycle – up, down and up
again
4. The parameter 150 value will be set to 1 after calibration finishes.
5. Test whether the positioning works correctly.
Slats positioning in Venetian blinds mode
Calibration using a connected momentary switch
1. Make sure:
o the device is supplied,
o the momentary switch is connected to S1 and S2 terminals,
o the device added to the Z-Wave network,
o parameter 151 is set to 2,

FIBARO ROLLER SHUTTER 3 Specifications

General

Device Type	Roller Shutter Controller
Protocol	Z-Wave
Radio Protocol	Z-Wave
Dimensions	42.5 x 38.25 x 20.3 mm
Mounting Box Requirements	Ø ≥ 50mm, depth ≥ 60mm
Protection Class	IP20
Maximum Load for AC Output	4.2A
Max Transmit Power	up to 6 dBm
Range	Up to 50m (open space)
Operating Temperature	0°C to 40°C
Z-Wave Frequency	868.4 MHz EU
Compatibility	Works with various Z-Wave and Z-Wave Plus certified devices
Radio Frequency	868.4 or 908.4 or 921.4 MHz EU frequency band