FiberHome AN6001-G16 Manual

8
Replacing a Module
 When replacement of a module is require
d
the module connector on the backplane b
e
replacement.
 If resistance is encountered when you ar
e
module, pull out the module and check w
h
mounting direction, slot position, and mod
correct. Do not force in a module in such
a

Do not contact a module with bare hands
Caution

Do
not
contact
a
module
with
bare
hands
.
ESD protection gloves or ESD protection
w
operating on a module.
 If a module is not to be installed immedia
t
its original ESD protection bag and put it i
place, keeping it away from sunlight and
s
electromagnetic radiation sources.
Align the left and right edges of
the module with the slide rails
in the target slot (with the
component side of the module
facing upward) and slowly
hth d l i l th
1
pus
h
th
e mo
d
u
l
e
i
n a
l
ong
th
e
slide rails.
Push the module to its position,
and tighten the captive screws
on the panel of the module to
lock it.
2
9
9
d
onsite, check
e
fore the
e
plugging a
h
ether the
ule type are
a
case.
Always wear
M3
Captive
screw
Cross
screwdriver
ESD protection gloves /
wrist strap
Always
wear
w
rist strap when
t
ely, pack it with
n a dry and cool
s
trong
9
9

FiberHome AN6001-G16 Specifications

General

Brand	FiberHome
Model	AN6001-G16
Category	Touch terminals
Language	English