7
Requirements for Installing the E
Space Requirement
Cabinet space requirement: The cabinet depth
Requirement for closing the cabinet door: Whe
space fiber passage unit and the door will not i
If you want to install the AN60001-G16 in a third-p
requirements.
Instruction
,
Heat Dissipation Requirement
The AN6001-G16 is designed with a heat dissi
forced into the equipment from the left and out
should be reserved on both sides of the equip
ventilation holes with good ventilation. The hol
60%.
When the cabinet is installed with multiple AN6
devices, a 1U space should be reserved on th
dissipation.
Power Supply Requirement
The third-party cabinet should be equipped with a
general).
Dust Prevention Requirement
-
G16 is not designed with an anti
-
8
equipment should be dustproof and compliant wit
uipment in a Third-party Cabinet
is no less than 300 mm .
the cabinet door is closed, the equipment wiring
interfere with each other
rty cabinet, make sure the cabinet meets the following
.
ation system based on air cooling, with the air
of the equipment from the right. Enough space
ent to allow air flow. The cabinet door should have
fraction of the cabinet door should be no less than
001-G16s or an AN6001-G16 together with other
upper and lower sides of each device for heat
Class C AC lightning protection module (20 KA in
st screen Therefore the cabinet housing the
.
,
the IP2X dust prevention requirement.