FiberHome AN6001-G16 Manual

 Make sure the external power supply is sh
u
not connect the power cables when they a
r
 Make sure the DC power input is cut off, a
n
 Never expose the joining parts of the pow
e
 If the bonding resistance between the equi
p
0.1 ohm, the ground cable should be re-ar
r

With the premise that the cables must be ar
Caution
Warning
12
Connecting Power Cables
12.1
Connecting External Power Cables

With
the
premise
that
the
cables
must
be
ar
power cables should be processed on site
a
 The power cables should be made of a con
t
connections.
Connection
PDP End
PDP260B (3000063) PDP296B (3000068)
-48V1 terminal (active)
-48V2 terminal (standby)
-48V_A terminal (activ
e
-48V_B terminal (stan
d
GND1 terminal (active)
GND2 terminal (standby)
0V_A terminal (active)
0V_B terminal (standb
y
PE terminal PE terminal
Note 1: Different PDPs use different types of external
i
Pd tO i
fth dl b fth
11
3
i
n
P
ro
d
uc
t
O
verv
i
ew
f
or
th
e mo
d
e
l
num
b
ers o
f
th
e po
w
u
t off before connecting the external power cables. Do
r
e powered.
n
d identify the switches to be used.
e
r cables and the power connectors unless necessary.
p
ment ground cable and the ground bar is larger than
r
anged.
rranged in compliance with the route, the external
rranged
in
compliance
with
the
route,
the
external
a
ccording to the “shortest” route principle.
t
inuous segment of copper core with no intermediate
Cable Type
Note 1
Opposite End
e
)
d
by)
-48 V power cable (blue)
External -48 V
terminal
y
)
0 V power cable (black)
External 0 V
terminal
PDP protection earth
ground cable (yellow-
/green)
PDP260B (3000063):
PDP296B (3000068):
Earth ground
point on the top
of cabinet
power cables. Please refer to the chapter on cables
bl
3
3
w
er ca
bl
es.

FiberHome AN6001-G16 Specifications

General

Brand	FiberHome
Model	AN6001-G16
Category	Touch terminals
Language	English