FiberHome AN6001-G16 Manual

The following introduces how to connect the external po
w
The protection earth ground cable for the PDP has been
PDP; users need only to connect the other end of the c
a
Instruction
Remove the front panel of the PDP.
3
Connect the power cables to the PDP and the
tl ldi til
4
M3
ex
t
erna
l
power supp
l
y
d
ev
i
ce respec
ti
ve
ly
.
0 V power cable
-48 V power cable
Processin
g
External
“
Cut
Wrap
Cri
1
4
g
Power Cables
Cut
-
Wrap
-
Cri
Wrap the bare end of the cable with an insul
a
prevent short circuit during cable layout.
2
1
Measure the power cable and cut an approp
r
of it as needed with a wire clipper on site.
Insulate the terminal with an insulating tape o
r
shrinkable tube.
4
3
After leading the cable to the desired position
,
insulating tape, strip the cable end with stripp
i
install the copper terminal onto the cable end
,
crimp it with hydraulic pliers.
To the power
supply device in the
equipment room
To the ground bar in the
equipment room
Connect the PDP protection earth ground cable to the
earth ground point of the cabinet.
1
Thread the -48 V and 0 V power cables into the cabinet.
2
w
er cables when the PDP296B (3000068) is used.
connected to the PE terminal before delivery of the
a
ble to the earth ground point on the top of the cabinet.
To the earth ground
point on the top of the
cabinet
External -48 V
DC power supply
PDP protection earth
ground cable
Earth ground
point on the top
of the cabinet
External 0 V
power ground
screwM6
Protection earth
ground cable
Captive
screw
M3
M6
Screw/bolt
Socket
wrench
Cross
screwdriver
M6
mp
Insulate
”
4
mp
-
Insulate
a
ting tape to
r
iate length
r
a heat-
,
remove the
i
ng pliers,
,
and then
1 2
3 4
Insulating
tape/heat-
shrinkable
tube
Hydraulic
pliers
Copper
terminal

FiberHome AN6001-G16 Specifications

General

Brand	FiberHome
Model	AN6001-G16
Category	Touch terminals
Language	English