3 - 8
AM35 Mainboard Manual
Precharge to Active (Trp)
This item allows users to set the clock time from Precharge to Active
command. The options are: 2T, 3T
Active to Precharge (Tras)
This item allows users to set the clock time from Active to Precharge
command. The options are: 5T, 6T
Active to CMD (Trcd)
This item allows users to set the clock time from Active to Read/Write
Delay command. The options are: 2T, 3T
DRAM Queue Depth
This item allows users to set DRAM queue depth.
The options are: 2 level, 4 level, 3 level.
DRAM Command Rate
This item allows users to set Address Time After command.
The options are: 2T Command, l T Command.
DRAM Timing
This feature allows user to select the way to set DRAM timing.
The options are: By SPD, Manual.
DRAM CAS Latency
If the CAS latency of your installed memory medule is 2 Cycle, The selec-
tion 2 will enhance system performance. The options are: 2.5, 2.
Bank Interleave
This item allows users to select the bank interleave function of DRAM,
when the feature DRAM Timing By SPD set at Disabled.
The options are: Disabled, 2 Bank, 4 Bank.
DRAM Clock
The feature allows users to select the DRAM clock.
The options are: 100 MHz, 133 MHz, Host CLK, By SPD.
To Next Page
Loading...
