3 - 19
BIOS Setup
Resume Time (hh:mm:ss)
If an ATX power supply is installed and when RTC Alarm Resume is En-
abled, this feature allows you to set the time of the alarm starts when the
RTC Alarm Resume From Soft Off is set to be Enabled.
The options are: hh (hour) - 0, 1, 2,.., 23; mm (minute) - 0, 1, 2,..,59; ss
(second) - 0, 1, 2,..,59.
Primary INTR
If set at ON, the Primary interrupt (the Primary option in the feature of IRQ#
Acitivity) will make the power management wake up the system.
The options are: ON, OFF.
Date (of Month)
This feature allows you to set the day of the alarm starts when the RTC
Alarm Resume From Soft Off is set to be Enabled. The options are: 0, 1..31.
IRQs Activity Monitoring
After the time period which you set, the system advances from doze mode
to suspend mode in which the CPU clock stops and the screen display is
off. At this moment, if the IRQ activity occurs, the system goes back to
full-on mode directly.
If the IRQ activity which is defined as Non Primary takes place, the system
remains off until the corresponding IRQ handler finishes.
The options of IRQ 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15 are: Enabled,
Disabled.
To Next Page
Loading...
