(lb)
weight units (F9)
This scale supports conversion among kg, g and lb. To enable this
conversion function, set F9 = ON. Press [UNIT] to shift among various
weight units.
The weight unit employed before power off will be employed when powered
on again.
6.4 TARE OFF THE WEIGHT OF A CONTAINER
Tare function is used to temporarily set this scale to zero (such as
cancelling the weight of a box or a container) in order to get the net weight
result
6.4.1 Manual Tare
When a container is used, follow the below steps to tare off the weigh of it
and to get a net weight result.
a. Remove all loads from platform,
b. Make sure that the ZERO INDICATOR is on. If not, press [ZERO],
c. Place container on platform,
d. Press [TARE] ,
e. NET INDICATOR appears to indicator tare is in effect and weight
displayed display is net weight. Refer to SPECIFICATIONS for
maximum tare range,
f. To cancel tare effect, remove all loads from platform and press
[TARE],
g. NET INDICATOR disappears. GROSS INDICATOR appears to
indicator tare effect has been removed and weight displayed display is
gross weight.
6.4.2 Auto Tare
(F12)
If this function is enabled, this scale will assume the first stable weight
applied is a container and will tare off the weight of it automatically.
To comply with the laws of certain countries and approval requirements, the imperial
weight unit may be disabled. Contact your dealer for more information.
To Next Page
Loading...
