Fidelity Electronics DM-3000 - Initial Setup

5. INITIAL SETUP
5.1 INTERNAL SETTINGS
Application parameters can be checked or set through internal setting
functions. Refer to 5.4 for description of all internal functions.
5.2 HOW TO ENTER AND SELECT INTERNAL FUNCTION
Follow the below steps to enter and select desired parameter of an internal
function.
a. Turn this scale off and on again,
b. Press [TARE] during countdown,
c. Display F1,
d. This scale is now in internal function,
e. Quick access to a function number
 Press 1 to go to F10,
 Press 2 to go to F20,
 Press 6 to go to F60 (for dealer and authorized personnel only),
 Press 8 to go to F80 (for dealer and authorized personnel only),
 Press 9 to go to F99 (for dealer and authorized personnel only),
 Press 0 to go to F1,
5.3 KEY FUNCTION DURING INTERNAL FUNCTION MODE
 [M+] = Enter, save and return,
 [ZERO] = Quit without saving,
 [FUN] = Go next,
 [UNIT] = Go previous,
 [CE] = Clear,
 [TARE] = Go to internal function during power on countdown, or set
F1 value being shown to zero and to display the net
span gain by applying additional load applied.