Fidelity Electronics DM-3000 - Page 22

6.5 MEMORY ACCUMULATION FUNCTION
6.5.1 To Accumulate a Transaction to Memory
10
11
12
a. Press [M+]
13
to save and accumulate data of current transaction to
memory,
b. This scale displays “≡ n”. M+ INDICATOR appears to indicate that
memory contains stored data. “≡ n”” means the total number of
transactions accumulated to memory,
c. This scale returns to normal display status after 2 seconds,
d. Repeat a to c for subsequent transactions
14
,
NOTE: -
1. Unstable weight cannot be accumulated to memory. If M+ is
pressed when weight reading is not unstable, this scale will reject
this command and response with 3 beeps.
6.5.2 Memory Recall and Clearance
a. Press MR to recall total accumulated weight from memory,
b. After MR is pressed, This scale displays “≡ n” (n means the number
of transactions accumulated) follow by the total accumulated weight
stored in memory,
c. At this point: -
 Press [ZERO] to quit, or
 Press [ZERO] followed by [CE] to clear memory and return operation.
M+ INDICATOR disappear to indicate no data is stored in memory.
6.6 FUNCTION MODES
This scale is equipped with the below function modes: -
 Piece Count,
 Percentage,
 Animal weighing (When F11 = on),
 Checkweighing (HI/LO check) for above functions.
10
Memory Accumulation Function support weighing function only.
11
Weight less than 20d (or 20d
1
for dual range) will not be accumulated to memory.
12
All data stored will be erased when this instrument is powered off.
13
or press [PRINT] if F17 is = ON
14
Weight must return to or below zero to enable another weight accumulation.